RC2 installation went fine on W10. Made a Q65-30A QSO OK on 6m using a TS-590SG. Switched configuration to the Icom 9700. Tried FT8 and it was OK. Tried Q65-30B on 144.170 and after one CQ it turned off the enable transmit. I turned enable transmit back on and it did two CQs, turned the enable transmit off, and produced the following rig error:
Hamlib error: Command rejected by the rig icom.c(3572):icom_set_ptt return rig.c(2549):rig_set_ptt return while setting PTT off This is a new behavior. Q65 worked OK on the Icom 9700 with RC1. Again, FT8 is OK. FYI, Joe, K1YOW
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
