On 28/03/2021 18:39, Harry E. Hoffman wrote:
Hi,
I am running V2.4.0-rc4 under Windows 10 Home 20H2 and I have noticed
that when running FT4 BEST S+P does not always function as expected. I
will engage the BEST S+P mode and it may or may not respond and try to
contact the strongest signal calling CQ that would be a NEW contact
for me. I have notice this when I had switched from FT8 to FT4 and if
I restart the program while in FT4 it usually will connect with the
best S+P station on the next cycle. I know that it will drop out of
BEST S+P after that contact and has to be engaged again if desired
which I do but it may only work for a contact or two and then fail
again. A restart or maybe letting several cycles pass it may start
responding again. I don't remember this being an issue when I was
running V2.2.2, I have noticed it in all the V2.4.0-rc versions. By
the way when it does pick a station and engages the transmitter it
does not always choose the strongest signal, I have seen it choose a
station with say a -17 over one that was a -07, is it not looking at
the minus sign and just seeing that 17 is larger then 7?
A feature suggestion, can the BEST S+P mode also be used in FT8 mode?
Can the mode be made latching rather then once and done, requiring a
manual re-engagement, or let the operator choose latching or not?
I made some Q65 contacts on 432 with a friend about 25 miles away, it
is a very interesting mode, we were able to make contacts with a
fraction of a watt.
73, stay safe, and thanks for all your work on this project.
Harry (KA2ENE)
Hi Harry,
I believe "Best S&P" is based on the highlighting options you have
enabled, not on signal strength.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
