This seems to be fixed now. I had to set the CODEC to single channel 48kHz and select LEFT in the wsjt audio settings, it has been running for over 24hrs without problems.
73 Conrad PA5Y From: Conrad PA5Y via wsjt-devel <wsjt-devel@lists.sourceforge.net> Sent: 17 July 2021 13:59 To: WSJT software development <wsjt-devel@lists.sourceforge.net> Cc: Conrad PA5Y <g0...@g0ruz.com> Subject: Re: [wsjt-devel] wsjt-x v2.5.0-rc3 This is a showstopper; the USB hubs are set so that power saving is not active. Does anybody have any ideas? Regards Conrad PA5Y From: Conrad PA5Y via wsjt-devel <wsjt-devel@lists.sourceforge.net<mailto:wsjt-devel@lists.sourceforge.net>> Sent: 17 July 2021 07:52 To: wsjt-devel@lists.sourceforge.net<mailto:wsjt-devel@lists.sourceforge.net> Cc: Conrad PA5Y <g0...@g0ruz.com<mailto:g0...@g0ruz.com>> Subject: [wsjt-devel] wsjt-x v2.5.0-rc3 Good morning. I have 2 instances of wsjt-x v2.5.0-rc3 running, one connected to a K3S and the other to a recently acquired TS-890S. The K3S audio input runs without problems for days, however the TS-890S does not. It fails after a short while. Usually stopping and restarting monitor restores the stream. Running the TS-890S on its own without the 2nd K3S instance makes no difference to the behaviour. Interestingly the 2 radios use the same audio drivers and com port drivers. If I use another type of software with the TS-890S the problem does not occur even after 30 hrs, which suggests that there is no hardware problem. Are there some diagnostics I can run or file that I can provide to help with debugging? I will start on 6m EME very soon and I will need Q65. Any help would be appreciated. Regards Conrad PA5Y
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
