I've been annoyed by this for a while and believe I've finally made sense of what's going on.
Rig - Yaesu FTDX10 Windows 10 WSJT-X v 2.6.1 6b6d74 When the IF bandwidth on the FTDX10 is set to anything above 3000 HZ the problem will show up after switching modes (from FT8 to FT4 for instance) and then selecting either "Tune" or "Enable Tx" (with "Enable Tx" the issue is delayed until the rig tries to transmit). At this point a "Rig Control Error" message pops up with the following details: Hamlib error: 11:newcat.c(100006):newcat_get_rx_bandwidth returning (-1) Invalid parameter 10:newcat.c(1609):newcat_get_mode returning(-1) Invalid parameter Hopefully this information will be of some help. Thanks, Jim Hocut Wt4W
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
