"2.8.0 improved, when used with OnmiRig, does not control rig frequency when Mode = None. It does control rig frequency when Mode = USB."
A bit more experimenting with 2.8.0. showed MODE=USB was a necessary but not sufficient condition. Rig control only seemed to work if Split operation was changed too. E.g. Start with Mode None, Split Rig - frequency control inop Set Mode USB - frequency control inop Set Split Fake it - Rig RX VFO responds. TX VFO unchanged Set Split Rig - Frequency control ok Set Mode none - Frequency control inop Set Mode USB - Frequency control inop Set Split none - Rig RX VFO responds. TX VFO unchanged Set Split Rig - frequency control ok This is only part of the problem. The fact that the WSJT-X dial frequency does change means the WSJT-X frequency display is not always rig dial frequency but is sometimes the commanded dial frequency. Shouldn't WSJT-X dial frequency always be the frequency reported by the rig and have some alert if rig frequency is not equal to commanded frequency? 73, Andy, k3wyc
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
