I didn't explain that clearly, in my haste. I set sked frequency to 10,368.200 and then set CFOM
In the Astronomical Data box the sked frequency showed as 10,368.200. It should of course stay the same throughout the QSO, although each period the rig Tx and Rx frequencies will change with Doppler (I don't adjust whilst transmitting) But what happened each changeover was that the Sked Freq shown in the Astronomical Data box was increasing by about 50Hz per period. For the receiving station, the effect, despite CFOM, was that I moved about 50Hz each period. Earlier in the day when looking at DL0SHF with it set for listen on Dx Echo, it was initially fine, but then despite WSJT showing the correct offset, the rig stayed on .024. I reset WSJT then all was OK again. It looks as if there's something odd about the communication between WSJT and rig - I've never seen this before. I can try again, and try also to revert to an earlier version, but just in case anybody else has noted odd behaviour..... David -----Original Message----- From: David Hilton-Jones <[email protected]> Sent: 07 October 2026 12:08 To: '[email protected]' <[email protected]> Subject: [wsjt-devel] V3.02.-RC1 Just noticed odd behaviour when using v3.02.rc1 for first time On 3cm EME Set up as usual but each successive 1 minute period on going to transmit the frequency increases 50Hz or so. Using CFOM as usual. Will need to test more, but anybody else noticed this? David, G4YTL _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
