On 7/15/09, Steve Rogers <[email protected]> wrote: > > Hello, Basically all 3 models are the tnc-2, I just started my mfj-1270c > yesterday and its works fine. You might want to check the interface>serial > tnc>activate on startup and also allow transmitting tabs . The 9600 baud tab > must be checked. You might want to check if your tnc is not in blp host mode > or kiss mode. Your 8n1 might be checked as well. I used minicom on ubuntu to > setup the /dev/ttyS0 at 9600 baud and 8n1. This might help your process with > xastir. Your tnc's are good units dont lose your faith yet. Steve kd5mkv > >> From: [email protected] >> To: [email protected] >> Date: Wed, 15 Jul 2009 16:55:46 -0500 >> Subject: [Xastir] MFJ-1278 tnc setup in xastir >> >> >> Hello group, >> >> I am a new member to this group with a question. >> >> >> >> I have installed xaster with andLinux.
It has been quite a while since I have done anything with andLinux, but the last time I did, I was not able to get serial communication to work. I'm thinking andLinux may be the problem as opposed to either a config issue or an Xastir issue. I could be wrong, though, because I have not tried a more recent version of andLinux. Regards, Lee - K5DAT Murphy, TX _______________________________________________ Xastir mailing list [email protected] http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
