Thank you everyone for confirming the setup I need. Watch for about 15
balloons from Topeka, KS early Saturday morning.
On Jul 16, 2009, at 2:27 PM, Tom Hayward wrote:
The D700/D710 have the broken KISS interface, the D700 more broken
than the other. You might want to leave it in normal serial packet
mode, in that case you want to select the tnc-startup.d700 and
tnc-stop.d700 files for the RF interface startup/shutdown files.
That should set up the D700 properly assuming it's in the correct
mode to begin with (packet/APRS?).
I'm getting a little off-topic here, but figured I would share my
settings here.
I use the the D710 in PACKET mode with Xastir. You can put A-band in
PACKET mode with the command TN 2,0.
My tnc-startup.d710 looks like this:
# $Id: tnc-startup.d710,v 1. 2009/06/03 10:28:58 sm7nwj Exp $
#
# Patrik Stromdahl, SM7NWJ.
#
# TNC Init file for KENWOOD TM-D710.
#
#Don't send CONTROL-C before this line
##META <no-ctrl-c>
##META <ctrl-c>
##META <ctrl-c>
##META <ctrl-c>
TC 1
##Pause for one second
##META <delay>
##META <delay>
##META <no-ctrl-c>
# You will have to select:
# TN 2,0 for band A
# TN 2,1 for band B
# on line below
TN 2,0
# Pause for one second, so that the TNC finishes it's startup.
##META <delay>
##META <delay>
# It's correct to duplicate ECHO and BEACON commands below.
ECHO OFF
##META <delay>
BEACON EVERY 0
##META <delay>
ECHO OFF
##META <delay>
BEACON EVERY 0
HBAUD 9600
Note: For 1200 baud APRS on 144.39, you'll want HBAUD 1200.
The original version of this file can be found at
http://groups.yahoo.com/group/TM-D710_TM-V71/files/CMDFiles%20-%20Xastir/
Tom KD7LXL
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
73's
Keith Kaiser
[email protected]
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
