On 12/17/2011 02:52 PM, Jerry Wetherholt wrote:
Done that all except inet to rf. I was working before under same settings but
not this time. Any other suggestions?
On Dec 17, 2011, at 1:41 PM, Steve Rogers<[email protected]> wrote:
Checkbox(s) File>Configure>Default Allow rf>to inet and inet to> rf traffic
Interface internet server passcode?
INTERFACE>allow rf> to inet and inet to>rf traffic
Steve kd5mkv
From: [email protected]
To: [email protected]
Date: Sat, 17 Dec 2011 19:22:33 +0000
Subject: [Xastir] help
i have a problem with my xastir for some reason. i had lost hard drive in a
previous computer and had to switch it out now my iagte seems not to be working
at all no. i see traffic comming in from the internet but anything i see from
my tnc does not get sent to internet dont know where i have went wrong any help
will be nice. i have in past about 90% of local traffic go through my igate and
digi not i have none and lost where i went wrong
jerry
KF5AOK
Semper FI
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
The two checkboxs for int rf and inet to rf and the internet server, passcode
prevented me from sending anything until I setup internet server properly! Interface
Control>Add>internet server enter passcode and aprs server, for example I use
texas.aprs2.net. you could use default but just a suggestion. kd5mkv steve
until
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
