On Sun, Nov 15, 2020 at 09:00:45PM +0000, we recorded a bogon-computron collision of the <[email protected]> flavor, containing: > Tom, Thanks for responding. I checked your instructions and checked my > settings. All seem to be as you suggest, with a few tweaks. I > discovered a major bleep up in my radio to tnc cable as the mic audio > was not wired correctly to the tnc.
Yes, that would do it. > Now that is corrected, I am tx > packet data, digi'd by a local igate and so things seem to be going > correctly. I will watch it now and see how things go. > Thank you again!! Glad you're up and running. Enjoy. > -----------------------------------------From: "Tom Russo" > To: "Xastir - APRS client software discussion" > Cc: > Sent: Sunday November 15 2020 3:37:01PM > Subject: Re: [Xastir] Xastir setup > > Set up your station configuration with coordinates in > File->Configure->Station > > Set up beacon type in File->configure->Defaults > > Set up beacon frequency in File->Configure->Timing > > Look in your interface settings in Interface->Interface Control and > make sure > that you have set up your TNC correctly as an interface and that > "Allow Transmitting" is turned on. > > If it is all right, then open View->Incoming Data to watch what your > interfaces > see, and then click "Interface->Transmit Now". You should see your > packet > show up in the Incoming Data window. If you do not, your interface > may not > be set up correctly. If you do see it, watch your radio to see if it > is > actually transmitting (that is, do it again while watching your > radio). > > If your radio is transmitting but nobody is seeing your packets, your > TNC > audio may not be set correctly and may be creating packet audio that > is not > decodable. See page 18 of the TNC Pi manual for how to adjust > transmit > audio on the device. > > On Sun, Nov 15, 2020 at 08:22:35PM +0000, we recorded a > bogon-computron collision of the flavor, containing: > > I am unclear about setting up station data and beaconing. I am a > fixed > > station, entered mu coordinates but am not sending any routine > packets > > with any data. Not showing up on aprs.fi. An Igate digi is in > within > > range of me. I see his packets and am receiving packets from about > 100 > > miles away so far. When I tested with a local ham to see if he saw > my > > packets he did not see any thing. I saw his packets(BPQ). > > I am using rasp pi model 3 and a tnc pi from coastal chip works. > > Thanks in advance for any help > > ChrisKB8UIH > > _______________________________________________ > > Xastir mailing list > > [email protected] > > [1] > > Links: > ------ > [1] http://xastir.org/mailman/listinfo/xastir > http://xastir.org/mailman/listinfo/xastir > /> > -- > Tom Russo KM5VY > Tijeras, NM > > echo > > _______________________________________________ > Xastir mailing list > [email protected] > http://xastir.org/mailman/listinfo/xastir -- Tom Russo KM5VY Tijeras, NM echo "prpv_a'rfg_cnf_har_cvcr" | sed -e 's/_/ /g' | tr [a-m][n-z] [n-z][a-m] _______________________________________________ Xastir mailing list [email protected] http://xastir.org/mailman/listinfo/xastir
