That certainly prevents the port from blocking. The interface in xastir returns as 'up' but it doesn't appear to be reading packets off the TNC in the view-incoming data window. Looking in putty it still shows the incoming packets. So its not quite fixed yet.
From: "Jason KG4WSV" <[email protected]> Try the /dev/cu.whatever device special file. It’s been a few years but when I hit the same problem (well, Kermit not putty) switching to cu did the trick. -Jason > On Feb 7, 2021, at 8:44 PM, Eric Chamberlain <[email protected]> wrote: > > I've been trying to configure an interface to read the tinytrak4 TNC, which > is supposed to operate as KISS according to their docs. When I run PuTTY on > the /dev/tty.usbserial-1430 port I can see packets coming in from a test > transmitter. I close putty and open xastir so the port isn't blocking. When I > go to start the TNC interface, in mac it hangs without messages in the > terminal window. On the putty it doesn't hang but there's nothing. There are > never incoming packets from the view data window. Unfortunately, Byonics say > they don't know much about xastir. I've tried this both on my mac and my > raspberry. The cable setup works for programming and PuTTY, so I don't think > its that or drivers. I think it comes down to settings. Is there anything I > can try? > _______________________________________________ > Xastir mailing list > [email protected] > http://xastir.org/mailman/listinfo/xastir _______________________________________________ Xastir mailing list [email protected] http://xastir.org/mailman/listinfo/xastir[http://xastir.org/mailman/listinfo/xastir] _______________________________________________ Xastir mailing list [email protected] http://xastir.org/mailman/listinfo/xastir
