What level of xCAT are you running and what type of cluster. Only our most recent levels have been tested with Redhat6.2 and actually we are still testing, but we need to know about any issues other who have tried it have found. You are correct, it is suppose to communicate back that the install/boot is complete and the install is finished.
Lissa K. Valletta 2-3/T12 Poughkeepsie, NY 12601 (tie 293) 433-3102 From: Don Avart <[email protected]> To: [email protected] Date: 03/22/2012 07:20 PM Subject: [xcat-user] Stateful install completes but doesn't reset node to boot xCat cluster configured with RHEL 6.2. When installing stateful nodes, installation proceeds fine until the end when the node reboots. The node remains in an install state and when it reboots it goes through the installation process again. I've been able to circumvent this by performing nodeset nodename boot. I'm assuming that the node should communicate back to the management node that the installation was successful and therefore set the node to boot. ------------------------------------------------------------------------------ This SF email is sponsosred by: Try Windows Azure free for 90 days Click Here http://p.sf.net/sfu/sfd2d-msazure _______________________________________________ xCAT-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/xcat-user ------------------------------------------------------------------------------ This SF email is sponsosred by: Try Windows Azure free for 90 days Click Here http://p.sf.net/sfu/sfd2d-msazure _______________________________________________ xCAT-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/xcat-user
