I’m trying to bring up a new system, but have run into a dead end. I get no
error message other than a blinking question mark in a diamond (some
un-assigned UTF character):
CLIENT MAC ADDR: 84 8F 69 FD 4F 28 GUID: 44454C4C 4300 1042 8054 B6C04F355631
CLIENT IP: 192.168.91.9 MASK: 255.255.240.0 DHCP IP: 10.10.1.167
GATEWAY IP: 192.168.92.54
PXE->EB:�P: 192.168.92.54
PXE->EB: !PXE at 98D2:0070, entry point at 98D2:0106
UNDI code segment 98D2:5210, data segment 9297:63B0 (586-632kB)
UNDI device is PCI 02:00.0, type DIX+802.3
546kB free base memory after PXE unload
xNBA initialising devices...ok
xCAT Network Boot Agent
iPXE 1.0.3-131028 (d603e) -- Open Source Network Boot Firmware -- http://ipxe.or
g
Features: HTTP HTTPS iSCSI DNS TFTP bzImage ELF PXE PXEXT
net0: 84:8f:69:fd:4f:28 using undionly on UNDI-PCI02:00.0 (open)
[Link:up, TX:0 TXE:0 RX:0 RXE:0]
DHCP (net0 84:8f:69:fd:4f:28)... ok
net0: 192.168.91.9/255.255.240.0 gw 192.168.92.54
Next server: 192.168.92.53
Filename: http://192.168.92.53/tftpboot/xcat/xnba/nets/192.168.80.0_20
http://192.168.92.53/tftpboot/xcat/xnba/nets/192.168.80.0_20... ok
http://192.168.92.53/tftpboot/xcat/genesis.kernel.x86_64... ok
http://192.168.92.53/tftpboot/xcat/genesis.fs.x86_64.lzma... 74%
I’m assuming the genesis.fs finishes loading even though it read “74%,” and a
CSI code bounces the cursor up the screen before failing.
Where should I be looking for debug this?
Thanks,
John
------------------------------------------------------------------------------
Site24x7 APM Insight: Get Deep Visibility into Application Performance
APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month
Monitor end-to-end web transactions and take corrective actions now
Troubleshoot faster and improve end-user experience. Signup Now!
http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140
_______________________________________________
xCAT-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/xcat-user
