Hello,
I didn't test it, but it might be feasible, although it might not be
straightforward.
The CMC doesn't use a proprietary driver per se, it is used mostly to allow the
blades to be discovered in the correct order, and then addressed correctly.
But the blades themselves are Supermicro based motherboards, so the standard
IPMI commands should work.
The thing is to get the MAC addresses in the correct order to populate the
database.
Otherwise, the SGI SMC software has been replaced by HPCM:
http://www.hpe.com/software/hpcm
Best,
--
Nicolas
________________________________
From: Vinícius Ferrão <fer...@versatushpc.com.br>
Sent: Tuesday, August 28, 2018 21:33
To: xCAT Users Mailing list
Subject: [xcat-user] xCAT on SGI ICE X
Hello,
I would like to know if someone is running xCAT on SGI ICE X. Since the SGI ICE
X needs the CMC drivers I’m unsure if xCAT can be used to control the machines
instead of the proprietary software from the faded SGI.
Thanks,
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
xCAT-user mailing list
xCAT-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/xcat-user
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
xCAT-user mailing list
xCAT-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/xcat-user
