Dear Aanjhan,
> I downloaded the current tarball from
> http://opencircuitdesign.com/xcircuit/archive/xcircuit-3.6.138.tgz and
> compiled with tcl and tk support and ran the binary. The program
> crashed upon doing the following steps.
>
> Click on the Workspace to draw a wire. Without pressing escape go to
> Window -> Library Directory -> Select a component *crash*
I corrected this problem, which should also correct similar instances
in which the library page is accessed during any operation with an
event handler for mouse movement, like wire creation, box creation,
polygon editing, etc. The patch has been applied to the CVS source
and should appear in the new tarball by tomorrow.
Thanks for bringing the bug to my attention.
Regards,
Tim
+--------------------------------+-------------------------------------+
| Dr. R. Timothy Edwards (Tim) | email: [EMAIL PROTECTED] |
| Open Circuit Design, Inc. | web: http://opencircuitdesign.com |
| 22815 Timber Creek Lane | phone: (301) 528-5030 |
| Clarksburg, MD 20871-4001 | cell: (240) 401-0616 |
+--------------------------------+-------------------------------------+
_______________________________________________
Xcircuit-dev mailing list
[email protected]
http://www.opencircuitdesign.com/mailman/listinfo/xcircuit-dev
