Hello Philip,
This is using XCircuit version 3.7 revision 30. Acts the same
in rev 28.
I create a line with multiple points.
I then position the cursor over the end of the line and press
"e" to edit.
Then I press "d" to delete the point shown by the cursor - but
the first point in the line is removed while the cursor remains
over the last point.
If I select the first point or any middle points it works as
expected.
Once I had time to get around to looking at it, it was an obvious
mistake (two lines swapped; decremented the number of points on the
line before checking which point was being edited, so it would always
fail if the last point was being edited).
I have uploaded to the git repository. This is a major test of the
whole system setup. I moved opencircuitdesign.com back to my house, set
it up on a new computer, and have been debugging for the last few days.
The tarball may or may not appear tomorrow, depending on whether or not
I am missing any scripts or tools or files.
---Tim
+--------------------------------+-------------------------------------+
| Dr. R. Timothy Edwards (Tim) | email: [email protected] |
| MultiGiG, Inc. | web: http://www.multigig.com |
| 2645 Zanker Road, Suite 101 | phone: (408) 514-1375 |
| San Jose, CA 95134 | cell: (240) 401-0616 |
+--------------------------------+-------------------------------------+
_______________________________________________
Xcircuit-dev mailing list
[email protected]
http://www.opencircuitdesign.com/mailman/listinfo/xcircuit-dev
