David Edmondson wrote: > On 30 Jul 2008, at 1:40pm, Paul Fisher wrote: > >> 2) If bridged networking does not work via the iwk0 interface, what >> are >> the steps to create an internal NAT network like what is described in: >> >> http://blogs.sun.com/droux/entry/private_virtual_networks_for_solaris >> >> I understand that crossbow has not been integrated fully yet, but that >> some basics have in place to support xvm. Is there enough to get >> something like this going? If so, how? >> > > Unfortunately, there aren't all of the pieces integrated to take the > approach that Nicolas describes, in particular the etherstub code is > not yet present. > > Something that you might try when connected to the network via iwk0 is: > - use e1000g0 as the 'bridge' device for the domain, > - create another VNIC over e1000g0 for use by dom0 (let's call that > 'vnic99'), > - plumb and configure vnic99 in dom0, > - now dom0 and domU can communicate via the VNICs over e1000g0, even > if e1000g0 is down, > Thank you very much. I've gotten this far (actually it looks like the virt-install created such a vnic already.), but ...
> - install NAT rules, routing configuration, etc. such that traffic > from the guest domain can be passed out through iwk0. > So I should be able to use the instructions on that blog to setup that forwarding... I'll report back on that. Thanks again! -- paul _______________________________________________ xen-discuss mailing list [email protected]
