To bump this thread, did you actually get this working?
I have an etherstub with two vnic's attached one for dom0, and I also have one
attached to a zone. These two can communicate between eachother and are working
fine.
When I create a virtual machine using virt-install I have been specifying this
etherstub as the bridge. When I run dladm show-link, it shows that the vm is
running over the etherstub.
When running ifconfig -a in the vm I get this:
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
xnf0: flags=1004843<UP,BROADCAST,RUNNING,MULTICAST,DHCP,IPv4> mtu 1500 index 2
with no information for xnf0 (although sometimes it has the ip address 0.0.0.0.
I have tried plumbing xnf0 to give it an ip address but the other vnic's still
don't recognize it.
Any insight into this would be much appreciated.
--
This message posted from opensolaris.org
_______________________________________________
xen-discuss mailing list
[email protected]
