Hi

After a couple of month I try to recompile xenomai and now neither my 
Powerbook nor my PPC405 build start up. I accepted all default values which 
showed up done in a "make oldconfig" (e.g.
All I get is:
## Transferring control to Linux (at address 00000000) ...
id mach(): done
MMU:enter
MMU:hw init
MMU:mapin
MMU:setio
MMU:exit
setup_arch: enter
setup_arch: bootmem
ocp: exit
The xeno-part of my config is:
CONFIG_XENOMAI=y
CONFIG_XENO_OPT_NUCLEUS=y
CONFIG_XENO_OPT_PERVASIVE=y
CONFIG_XENO_OPT_PIPE=y
CONFIG_XENO_OPT_PIPE_NRDEV=32
CONFIG_XENO_OPT_REGISTRY=y
CONFIG_XENO_OPT_REGISTRY_NRSLOTS=512
CONFIG_XENO_OPT_SYS_HEAPSZ=128
# CONFIG_XENO_OPT_ISHIELD is not set
CONFIG_XENO_OPT_STATS=y
# CONFIG_XENO_OPT_DEBUG is not set
CONFIG_XENO_OPT_WATCHDOG=y
CONFIG_XENO_OPT_TIMING_PERIODIC=y
CONFIG_XENO_OPT_TIMING_PERIOD=0
CONFIG_XENO_OPT_TIMING_TIMERLAT=0
CONFIG_XENO_OPT_TIMING_SCHEDLAT=0
# CONFIG_XENO_OPT_SCALABLE_SCHED is not set
CONFIG_XENO_OPT_TIMER_LIST=y
# CONFIG_XENO_OPT_TIMER_HEAP is not set
# CONFIG_XENO_OPT_SHIRQ_LEVEL is not set
# CONFIG_XENO_OPT_SHIRQ_EDGE is not set
# CONFIG_XENO_HW_FPU is not set
CONFIG_XENO_SKIN_NATIVE=y
CONFIG_XENO_OPT_NATIVE_PIPE=y
CONFIG_XENO_OPT_NATIVE_PIPE_BUFSZ=4096
CONFIG_XENO_OPT_NATIVE_SEM=y
CONFIG_XENO_OPT_NATIVE_EVENT=y
CONFIG_XENO_OPT_NATIVE_MUTEX=y
CONFIG_XENO_OPT_NATIVE_COND=y
CONFIG_XENO_OPT_NATIVE_QUEUE=y
CONFIG_XENO_OPT_NATIVE_HEAP=y
CONFIG_XENO_OPT_NATIVE_ALARM=y
CONFIG_XENO_OPT_NATIVE_MPS=y
CONFIG_XENO_OPT_NATIVE_INTR=y
# CONFIG_XENO_SKIN_POSIX is not set
# CONFIG_XENO_SKIN_PSOS is not set
# CONFIG_XENO_SKIN_UITRON is not set
# CONFIG_XENO_SKIN_VRTX is not set
# CONFIG_XENO_SKIN_VXWORKS is not set
# CONFIG_XENO_SKIN_RTAI is not set
CONFIG_XENO_SKIN_RTDM=y
CONFIG_XENO_SKIN_UVM=y
# CONFIG_XENO_DRIVERS_16550A is not set
# CONFIG_XENO_DRIVERS_TIMERBENCH is not set

DOes anybody have a clue?

Best regards
-- 
Niklaus Giger

_______________________________________________
Xenomai-core mailing list
Xenomai-core@gna.org
https://mail.gna.org/listinfo/xenomai-core

Reply via email to