Hi Jan, I have used an standard vanilla kernel without any patches and this delivered the same results. It seems to be an issue that is not related to Xenomai or Adeos. When I pass the kernel parameter hdb=noprobe the kernel boots fine (however, I can not access the CD-ROM drive anymore...). I think the reason for that could be, that my hard disk is a SATA drive and the only IDE device is the CD ROM on hdb, I do not have a hda device. There are many entries on that somewhere in the internet... I'll try the same on a 2.6.19.1 kernel to see if this solves the issue.
Thanks for the hints! Regards Mathias > M. Koehrer wrote: > > Hi Jan, > > > > I tried the kernel parameter maxcpus=0 on my SMP enabled, Xenomai-patched > kernel (same as in mails below). > > The kernel does not boot. > > It stops after a couple of messages: > > IOAPIC[0]: Invalid reference to IRQ 0 > > OK, a few things more to verify: > > - kernel boots fine with your scenario except CONFIG_IPIPE disabled? > - problem persists with 2.6.19-ipipe-1.6-02? > > And could you post your .config and the boot log? > > Jan > > -- Mathias Koehrer [EMAIL PROTECTED] Viel oder wenig? Schnell oder langsam? Unbegrenzt surfen + telefonieren ohne Zeit- und Volumenbegrenzung? DAS TOP ANGEBOT JETZT bei Arcor: günstig und schnell mit DSL - das All-Inclusive-Paket für clevere Doppel-Sparer, nur 44,85 inkl. DSL- und ISDN-Grundgebühr! http://www.arcor.de/rd/emf-dsl-2 _______________________________________________ Xenomai-help mailing list [email protected] https://mail.gna.org/listinfo/xenomai-help
