roland Tollenaar wrote:
>
> FATAL: Error inserting xeno_can_peak_dng (xeno_can_peak_dng.ko): No
such
> device
Is there som additional kernel output visible via "dmesg"?
Yes:
SCSI device sdb: 3963904 512-byte hdwr sectors (2030 MB)
sdb: Write Protect is off
sdb: Mode Sense: 43 00 00 00
sdb: assuming drive cache: write through
SCSI device sdb: 3963904 512-byte hdwr sectors (2030 MB)
sdb: Write Protect is off
sdb: Mode Sense: 43 00 00 00
sdb: assuming drive cache: write through
sdb: sdb1
sd 3:0:0:0: Attached scsi removable disk sdb
usb-storage: device scan complete
ERROR! No SJA1000 device found!
ERROR while trying to register SJA1000 device -19!
Init failed with -19
are the final lines.
OK ==> the device cannot be accessed. Either the I/O address "0x378" and
partport type "epp" is incorrect (you did not answer my question on
that) or the parallel port is not operational (power off, etc.).
Please check what is actually selected in the BIOS of your system.
How do you have configured the parport in the kernel? Are there modules
loaded (check /proc/modules)? Retry after removing lp and parport_pc:
Have looked can't see any. Have attached the output of /proc/modules
$ rmmod lp
$ rmmod parport_pc
I get a message that it cannot find these modules in /proc/modules
Try "modporbe parport". If the module does not exists, configure and
rebuild your kernel with parport support.
In the meantime I'm going to apply the fix Jan mentioned.
Wolfgang.
_______________________________________________
Xenomai-help mailing list
[email protected]
https://mail.gna.org/listinfo/xenomai-help
