Philippe Gerum wrote:
> On Mon, 2010-08-09 at 13:50 +0200, Gilles Chanteperdrix wrote:
>> Philippe Gerum wrote:
>>> On Mon, 2010-08-09 at 02:54 -0700, Bob Feretich wrote:
>>>> I am converting my second driver to RTDM. This one receives a
>>>> negativing going edge triggered interrupt on GPIO133 of the OMAP3
>>>> chip.
>>>>
>>>> I have...
>>>> ret = rtdm_irq_request(&adis_data_rdy_irq_handle, irq,
>>>> adis_data_rdy_irq_handler,
>>>> RTDM_IRQTYPE_EDGE,
>>>> "asuspidvr", ctx);
>>>> then...
>>>> ret = rtdm_irq_enable(&adis_data_rdy_irq_handle);
>>>>
>>>> but the interrupt handler is never invoked.
>>>>
>>>> cat /proc/xenomai/irq shows:
>>>> IRQ CPU0
>>>> 37: 15815 [timer]
>>>> 39: 0 asuspidvr
>>>> 48: 0 asuspidvr
>>>> 91: 0 asuspidvr
>>>> 293: 0 asuspidvr
>>>> 418: 0 [virtual]
>>>>
>>>> IRQ 293 in the interrupt that should be happening.
>>>>
>>>> I can see the pulses on the input pin and the non-rt version of the
>>>> driver sees the interrupts, so that excludes hardware issues and
>>>> u-boot pin configuration issues.
>>>>
>>>> Any suggestions?
>>>> Regards,
>>>> Bob Feretich
>>>>
>>>>
>>>> __
>>> For some reason, that IRQ line may not be properly enabled by the core
>>> code. Could you introduce this patch? If a valid routine is reported in
>>> the kernel log message, you could locate it by address, from a kernel
>>> image objdump.
>> There may also be more to do than enabling the irq line, such as
>> programming the hardware to enable irq for this gpio, set the type
>> (edge, level) and so on. You can try and call request_irq, then free_irq
>> before calling rtdm_request_irq to see if request_irq would trigger some
>> actions that rtdm_request_irq does not trigger.
>>
>
> If you mean that beagle_twl_gpio_setup() still has to be called at this
> point, then we probably have something broken at ipipe level.
I was rather thinking about gpio_irq_type, which is normally called
through "set_irq_type". I wonder however, if calling this function for
an irq registered through rtdm will not screw things up, especially
since it changes the flow handler, or do nothing because the irq has not
been registered with request_irq.
--
Gilles.
_______________________________________________
Xenomai-help mailing list
[email protected]
https://mail.gna.org/listinfo/xenomai-help
