On Wed, Feb 18, 2015 at 07:12:43PM +0100, Jan Kiszka wrote:
> On 2015-02-18 18:55, Gilles Chanteperdrix wrote:
> > On Wed, Feb 18, 2015 at 06:52:14PM +0100, Jan Kiszka wrote:
> >> Hi Gilles,
> >>
> >> I noticed on ARM (AM335 TI board) that the SIGDEBUG if the related test
> >> apparently only gets delivered to the receiver after it invokes a
> >> syscall, not on return from its secondary mode migration. Therefore the
> >> page fault test of the sigdebug smokey test fails (tested with Xenomai
> >> 3), and I bet the watchdog test as well. Is this a known limitation?
> >
> > Xenomai 2.6 sigdebug works fine on omap3 (very near from an
>
> Will try 2.6 next.
>
> > arm33xx). That being said, the AM3xx port is not part of the main
> > line I-pipe, and based on a non mainline kernel, so it is difficult
> > for me to answer this question.
>
> Then I'm possibly not building all recommended bits - I'm on 3.14 I-pipe
> upstream. That seems to work fine in general. Which version are you
> referring to?
The one documented in arm/patches/README
--
Gilles.
_______________________________________________
Xenomai mailing list
[email protected]
http://www.xenomai.org/mailman/listinfo/xenomai
