It looks like the FP detection routine is failing to detect the correct
panel info. it looks like you are using 4.3.0. you should upgrade to
the CVS version. there were major fixes to the monitor/lcd detection
code after 4.3 was released.
Alex
-----------------------------------------
[I sent this a few days ago, but didn't seem to get a response (perhaps
because
I was not on the list. I did get one bounce message, though ;) I'm
hoping a
resend will get a response ;)]
-Brian
I've been fighting with this for a day or two now, and I've run out of
leads
to fix it. Help pointing me in the right direction would be
appreciated.
I have an IBM T40 running FreeBSD 5.1 (stock) with a ports collection
from
9/24, as there were apparently some changes to the XFree86 port between
5.1 and
that date (and I wanted to make sure I had the latest patches). The
version
of XFree86 is 4.3.0
Using X -configure and xf86config generate similar, yet distinctly
different
config files. Both have the same problem, however, in that when I start
X,
I get either signal 6s, or signal 11s, and it crashes, whether I use
XFree86
directly, or run xdm.
I've gone through the log, and made changes to load the modules to get
rid
of the missing symbols from the generated config file. At this point,
the
only thing that looks odd is the reported screen resolution of
65536x65535,
but can't find a way to over ride it.
I've included my dmesg output from the laptop, so that the hardware I'm
running can be seen. I've also included my XF86Config file, and the log
from
a typical run.
Again, a working config or pointers on what to try next would be
greatly
appreciated.
-Brian
__________________________________
Do you Yahoo!?
The New Yahoo! Shopping - with improved product search
http://shopping.yahoo.com
_______________________________________________
XFree86 mailing list
[EMAIL PROTECTED]
http://XFree86.Org/mailman/listinfo/xfree86
