|
Using XFree86 4.3.0
Radeon 7000 ve
Sony CPD 100ES
This monitor supports 800x600 at 85Hz, and lists it
in its table of VESA modes. I have a high sensitivity to flicker
and need the higher refresh rate.
I used the xf86config utility and entered the
correct mode ranges from the monitor manual. However, it seems that the
system has used a refresh rate that is lower than 70. I get lots of
flicker.
Is there a very simple way to force the monitor to
use this video mode?
I used gtf and obtained a modeline for this refresh
rate, but I'm not sure where to put it, and I'm hoping there is an easier
way.
Thanks in advance.
Gary Haithcock
|
