Gentlmen,
I installed on an old compaq deskpro 2000 (pentium 133) that I upgraded to
128 MB RAM, Linux Mandrake 10.0 with graphical interface KDE.
It starts in textual mode and launching kde, un error occurred.
I added a section of thelog file for diagnostic.
Thank-you, in advance,for your support.
Angelo
XFree 86 version 4.3.0.1
X protocol version 11, revision 0, release 6.6
Build operating system:Linux 2.6.0.1 mdkenterprise i686 ELF
(--)PCI: (0:15:0)Cirrus Logic GD5436 (Alpine)rev0,[EMAIL PROTECTED]/24
(II)Load Module : �Cirrus�
(II) v4l driver for video 4 linux
(II) CIRRUS driver for cirrus chipset cirrus logic CLGD 5436
(II)Primary device is : PCI 00:0f:0
(--) assigning device section with no bus ID to primary device
(--)chipset CLGD5436 found
(II)loading sub module : �Cirrus Alpine�
(II)load module �Cirrus Alpine�
(II)setting vga for screen 0
(II)loading sub module �vgahw�
(II)load module: �vgahw�
(II)CIRRUS: vgaHWGet IOBase:hwp-> IO Base is 0X03d0,hwp->PIOOff set is
0X0000
(II)loading sub module �int 10�
(II)load module �int 10�
(II)CIRRUS(0):inizializing int10
(II)CIRRUS(0):primary VBIOS segment is 0X0000
(WW)System lacks support for changingMTRRS
(**)cirrus (0):Dept24,(--)framebuffer bpp24
RGB weight888
Default visual is TrueColor
Using SW cursor
Linear framebuffer at 0X40000000
(EE)nonvalid MMIOaddress in PCI config space
(--)not using MMIO
(II)loading sub module �i2c�
(II)loading sub module �ddc�
(EE)CIRRUS (0) inizialization failed
(--):using gamma correction(1.0,1.0,1.0)
(--)memory config reg 1 is 0X11
(--)memoty config reg 2 is 0X21
(--)video RAM 1024 Kbyte
(--)min pixel clock is 12 MHZ
(--)max pixel clock is 28MHZ
(II)CIRRUS(0)monitor 1 using hsync range of 30.00-60.00 KHZ
vrefresh range of
50.00-125.00 HZ
(EE)CIRRUS (0)virtual width (800)is too large for the hardware (max 2048)
(--)unload module �cirrus�
(--)unload module �ddc�
(--)unload module �i2c�
(--)unload module �int 10�
(--)unload module �vgahw�
(--)unload module �cirrus alpine�
(EE)Screen found but nonehave a usable configuration
fatal server error:no screens found
________________________________________________
Message send using Micso Internet Webmail
_______________________________________________
XFree86 mailing list
[EMAIL PROTECTED]
http://XFree86.Org/mailman/listinfo/xfree86
