Re: [XFree86] Need a configuration file(XF86Config) on Redhat Linux 7.2 for Mercury Mother Board(P4PM800M7) with Via Chipset

[Mark Vojkovich]

   We need to see the /var/log/XFree86.0.log file.

                Mark.

On Mon, 22 May 2006, Vijay Bhaskar Reddy D (vijaybrd) wrote:

> Hello,
> I am facing problems installing Redhat Linux 7.2 on my assembled PC.
> I couldnt get GUI after installing Redhat LINUX 7.2, may be
> because of improper config setting.  Can you please
> suggest me the exact device and screen sections
> configuration for the specifications given below, so
> that I can configure manually by editing XF86Config
> file?
> Video-card:
>  S3's Savage4, VideoRAM supported is 32MB, its a built
> in card on Mercury Mother Board(P4PM800M7) with Via Chipset
> Monitor Specification:
>  LG 17" CRT Monitor - 700E   Horizontal Freq: 30 - 71 KHz
>   Vertical Freq: 50 - 160 Hz.
> http://www.lgezbuy.com/productdisplay.aspx?mapid=2168&modno=700E.&region
> =28&pid=2153&catid=196
> <http://www.lgezbuy.com/productdisplay.aspx?mapid=2168&modno=700E.&regio
> n=28&pid=2153&catid=196>
> I am giving the last few lines of log file contents
> generated by Xserver below:
>  .....  .  . . . . . . . . . .
>  . . . . . . . . . . ..
>  . ..  .. . . . . . ..
> (II) SAVAGE: driver (version 1.1.19) for S3 Savage
> chipsets: Savage4,Savage3D, Savage3D-MV, Savage2000,
> Savage/MX-MV, Savage/MX,Savage/IX-MV, Savage/IX,
> ProSavage PM133, ProSavage KM133, Twister,TwisterK
> (II) Primary Device is: PCI 01:00:0
> (--) Assigning device section with no busID to primary
> device
> (EE) No devices detected.
> Fatal server error:
> no screens found
> When reporting a problem related to a server crash,
> please send
> the full server output, not just the last messages.
> This can be found in the log file
> "/var/log/XFree86.0.log".
> Please report problems to xfree86 xfree86 org
> ......................
> ....... . .. .. . . . ..
>  .... .. . . .. . . ..
>
> OR you may suggest some generic settings which should
> work for any kind of card. Because when I can get GUI
> based installation screen while installation LINUX,
> I think I can use the same settings(used by LINUX
> installation process), so can you please let me know
> the default settings(for video card and monitor) used
> by LNUX installation wizard to diplay its GUI.
>
> Thanks in advance,
> Vijay
>
_______________________________________________
XFree86 mailing list
XFree86@XFree86.Org
http://XFree86.Org/mailman/listinfo/xfree86