This question is about gMFSK, but I cannot find a discussion group for
that, so if someone can point me to the right place, I would appreicate it.
This is my second installation of xlog, on a different computer. In my
first install, both gmfsk and xlog worked fine, but that computer had a
serial port. This new computer does not have a serial port, and I am
using USB0 to talk to the radio from xlog. I have a serial cable coming
out of my Ten-Tec Omni VI, and a serial-to-USB converter following that
to the computer. I have xlog working, and it reads frequency and mode
data from the radio using Hamlib, with Device set to /dev/ttyUSB0.
gMFSK does not have this choice, but I changed one of the entries to
this value. It does not work.
I have Hamlib in gMFSK set to use real frequencies in waterfall and to
use Hamlib PTT. Neither of these work. When I try to transmit, I get
the popup message: sound_open_for_write: opensnd: open: /dev/dsp: Device
or resource busy. This happens whether or not xlog is running.
Furthermore, when I start gMFSK, I receive the following two error
messages, whether or not xlog is running.
Message 1:
Hamlib init: rig_set_ptt failed: Communication bus error.
Hamlib PTT disabled
Message 2:
Hamlib init: rig_get_freq failed: Communication bus error
Does anyone know whether gMFSK will work with a USB port to the device,
and, if so, how I should set it up? Both use Hamlib, so I assume that
it is possible.
As I said at first, if there is a more appropriate place to take this
question, please point me there.
Jan, KX2A
_______________________________________________
Xlog-discussion mailing list
[email protected]
http://lists.nongnu.org/mailman/listinfo/xlog-discussion
