Sure. I think it will work for a simple use cases when there is only one key. And yes, for anything more sophisticated custom code is required.
Aleksey On 8/9/17 10:58 AM, Roumen Petrov wrote: > Aleksey Sanin wrote: >> It was discussed in the mailing list in the past. You need to >> create openssl config file to use the engine by default and > Hmm, in general this configuration will not work. > > Engines that operate with keys material stored externally cannot be set > as default - usually this break operations with keys stored differently > (file and etc.). > >> pass it to xmlsec1 command line tool. > Perhaps it will work for simple command line case with single key. > > On other side openssl command line option -engine specify where is > located key (call method ENGINE_load_private_key). > > Regards, > Roumen > _______________________________________________ > xmlsec mailing list > [email protected] > http://www.aleksey.com/mailman/listinfo/xmlsec _______________________________________________ xmlsec mailing list [email protected] http://www.aleksey.com/mailman/listinfo/xmlsec
