https://bugs.freedesktop.org/show_bug.cgi?id=27001
--- Comment #6 from Ancoron <[email protected]> 2010-04-04 02:46:13 PDT --- Created an attachment (id=34657) --> (https://bugs.freedesktop.org/attachment.cgi?id=34657) Xorg.0.log from KMS boot on 2.6.34-rc3 Just tried kernel 2.6.34-rc3 (not from mainline, self compiled, no source changes). Same result as before. Software is fine, not complaining about anything. But there are some things that I noticed when booting with KMS enabled: - no EDID detection of the monitor (driver does that in UMS) - outputs get swapped finally: (II) RADEON(0): Output DVI-0 using monitor section Dell 3007WFPHC (II) RADEON(0): Output DIN has no monitor section (II) RADEON(0): Output DVI-1 has no monitor section (II) RADEON(0): Output DVI-0 disconnected (II) RADEON(0): Output DIN disconnected (II) RADEON(0): Output DVI-1 connected (II) RADEON(0): Using exact sizes for initial modes (II) RADEON(0): Output DVI-1 using initial mode 2560x1600 With UMS this results in DVI-0 becoming connected. The log says previously that the driver detected the monitor on DVI-1 which is incorrect so the final swapping corrects the output. With KMS however the initial detection is correct and the output swapping seems to make it wrong. -- Configure bugmail: https://bugs.freedesktop.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug. _______________________________________________ xorg-driver-ati mailing list [email protected] http://lists.x.org/mailman/listinfo/xorg-driver-ati
