On Sun, Mar 10, 2002 at 12:43:15PM -0800, Mark Vojkovich wrote:
> The NVIDIA driver supports multiple cards (I have a GeForce2 +
> TNT2 system as my main development machine), but it sometimes
> has a difficult time posting the second head properly so you
> may have to Option "UseInt10Module" to the Section "Device"
> for the secondary card (the one the console does not come up
> on).
OK I've been experimenting with this a little bit. I added
Option "UseInt10Module" "On"
and it didn't seem to make much difference (the log file confirms
that the int10 module is being used).
The AGP card is on IRQ 7 by itself. The PCI card is on IRQ 10,
shared with the sound card and the UDMA controller.
/proc/nv/card* shows AGP is disabled for both cards.
(Not sure why, as I've seen it enabled for both cards before).
Both cards seem to work fine individually; I'm using the second
head only to write this. (Starting X with -screen to select
the screen works fine.) I can run OpenGL stuff on either head
successfully.
If I start with both screens enabled, then I get the NVIDIA
logo on both heads, then the xdm login prompt appears on the
first screen (the AGP card) but the NVIDIA logo stays on the
other. It hangs immediately after logging in.
Here's my two Device sections for the video cards:
# GeForce2 Titanium on AGP
Section "Device"
Identifier "GF2TI"
BusID "PCI:1:0:0"
Driver "nvidia"
EndSection
# TNT2 on PCI
Section "Device"
Identifier "TNT2"
BusID "PCI:0:11:0"
Driver "nvidia"
Option "UseInt10Module" "On"
EndSection
Any suggestions?
thanks,
Hamish
--
Hamish Moffatt VK3SB <[EMAIL PROTECTED]> <[EMAIL PROTECTED]>
_______________________________________________
Xpert mailing list
[EMAIL PROTECTED]
http://XFree86.Org/mailman/listinfo/xpert
