the vesa drivers didn't work for me, ideas? Dave
Alan Hourihane wrote: >On Sun, Jun 02, 2002 at 02:04:36 -0500, David Loszewski wrote: > > >>Dr Andrew C Aitchison wrote: >> >> >> >>>On Sat, 1 Jun 2002, David Loszewski wrote: >>> >>> >>> >>> >>> >>>>I have a Hercules Kyro 4000XT AGP card installed on a FreeBSD 4.5 system >>>>in which I'm trying to run XFree86 4.2 but when I try to do a 'XFree86 >>>>-configure' I get an error. Attached to this email is my XFree86.0.log >>>>and the output when I do a 'scanpci -v' command. If there is a >>>>resolution for this please get back to me ASAP. >>>> >>>> >>>> >>>> >>>That KYROII chip wasn't known to XFree86 at the time of 4.2, but is >>>recognised by the current CVS source, if you wish to try building it >>>yourself (not really recommended for newbies). >>> >>>However, I can't see from the source which driver supports that chip, >>>so it *may* be that the chip is recognised but not yet supported :-(. >>> >>> >>> >>> >>> >>it's not the KyroII chip though, it's just the Kyro chip, the first one. >> >> > >Doesn't really matter. Kyro I or II isn't directly supported. You >can use the vesa driver. Or better still go and get the binary >only drivers from PowerVR. > >I think they're available at http://www.powervr.com/downloads > >Alan. >_______________________________________________ >Xpert mailing list >[EMAIL PROTECTED] >http://XFree86.Org/mailman/listinfo/xpert > > > > _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert
