Hi there, Whenever I try a low res mode like 800x600 on my laptop, XFree86 automatically selects a doublescan mode, at the expense of a higher vertical frequency (I get doublescan @ 60 Hz, but I would prefer singlescan @ 85 Hz or better). I think it is because XFree picks the mode with the highest dot-clock that still fits the monitor and video card specs, instead of the highest vertical frequency.
Is there any way to disable doublescan modes? Or to modify the order of preference for selecting modes at a given resolution? I looked on the man pages but I did not find anything. I know I could do it by listing all the desired modes in the monitor section and then specifying those, but I would like to avoid duplicating XFree's internal mode list. However, if this is the only currently available solution, where can I get the definition of standard modes used by XFree internally? Thanks in advance, Diego -- ------------------------------------------------------- Diego Santa Cruz PhD. student Publications available at http://ltswww.epfl.ch/~dsanta Signal Processing Institute (LTS1 / ITS / STI) Swiss Federal Institute of Technology (EPFL) EPFL - STI - ITS, CH-1015 Lausanne, Switzerland E-mail: [EMAIL PROTECTED] Phone: +41 - 21 - 693 26 57 Fax: +41 - 21 - 693 76 00 ------------------------------------------------------- _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert
