Yes, thanks Anton! On Tue, 14 Feb 2012 05:42:19 PM Anton Gladky wrote: > Hi Klaus, > > it should be ok in r3026. There was a typo in a formulation. > > Thanks for pointing that out. > > Anton > > 2012/2/14 Klaus Thoeni <931...@bugs.launchpad.net>: > > Hi Anton, > > > > well done! The information shown by the localhost are fine now. The only > > thing which is still strange is that the estimated day/time when > > finished is wrong even if the iter/sec is more or less constant. It > > gives dates like 20 March whereas the simulation is finished in 5 > > minutes. Towards the end of the simulation (90%) it's getting more > > realistic. The same problem exists for simulations starting from the > > beginning. > > > > Not sure how the time/date is estimated. But since value iter/sec is > > correct it shouldn't behave so strange. > > > > Thanks, > > Klaus > > > > On Tue, 14 Feb 2012 08:07:57 AM Anton Gladky wrote: > >> I hope r3025 will fix the bug. > > > > -- > > You received this bug notification because you are subscribed to Yade. > > https://bugs.launchpad.net/bugs/931263 > > > > Title: > > localhost info > > > > Status in Yet Another Dynamic Engine: > > Fix Released > > > > Bug description: > > When running a simulation, which has already some pre-history (e.g. > > load a simulation which has done already 100000 iterations and run > > some more simulations), in batch mode some information in localhost > > info are wrong. I guess the average iterations per seconds include the > > iterations from the loaded state. Therefore, the value is far to high > > and the estimate for the finishing time/date is as well wrong. When > > running without batch mode the controller is showing the correct > > value. > > > > To manage notifications about this bug go to: > > https://bugs.launchpad.net/yade/+bug/931263/+subscriptions
-- You received this bug notification because you are a member of Yade developers, which is the registrant for Yade. https://bugs.launchpad.net/bugs/931263 Title: localhost info Status in Yet Another Dynamic Engine: Fix Released Bug description: When running a simulation, which has already some pre-history (e.g. load a simulation which has done already 100000 iterations and run some more simulations), in batch mode some information in localhost info are wrong. I guess the average iterations per seconds include the iterations from the loaded state. Therefore, the value is far to high and the estimate for the finishing time/date is as well wrong. When running without batch mode the controller is showing the correct value. To manage notifications about this bug go to: https://bugs.launchpad.net/yade/+bug/931263/+subscriptions _______________________________________________ Mailing list: https://launchpad.net/~yade-dev Post to : yade-dev@lists.launchpad.net Unsubscribe : https://launchpad.net/~yade-dev More help : https://help.launchpad.net/ListHelp