Question #689592 on Yade changed: https://answers.launchpad.net/yade/+question/689592
Aleksander Grabowski posted a new comment: Hi Leonard, like you said, it is difficult to create one set of parameters that will provide proper results for different conditions. In my work, I used TriaxialCompressionEngine to perform some triaxial tests. As far as I'm concerned, when I wanted to properly prepare samples for two different confining pressures e.g. 100 kPa and 400 kPa, I had to use different friction angles between the particles (higher one for higher pressure), so the initial porosity was equal for both pressures (higher pressure will better squeeze the specimen). I used the same approach to reach different initial porosities. As far as I know, you can try to change your parameters a little, e.g.: - increasing micro friction angle will increase only the peak value of the stress-strain curve and the residual value will stay on the same level, - increasing young modulus will increase the global stiffness of the response. - changing moments law etaRoll parameter can change the placement of the peak value on the stress-strain curve. Cheers, Aleksander -- You received this question notification because your team yade-users is an answer contact for Yade. _______________________________________________ Mailing list: https://launchpad.net/~yade-users Post to : [email protected] Unsubscribe : https://launchpad.net/~yade-users More help : https://help.launchpad.net/ListHelp
