New question #700143 on Yade: https://answers.launchpad.net/yade/+question/700143
Hello, I simulated a deep granite sample with a peak stress of about 120MPa and a peak strain of about 0.015. After a lot of debugging, I selected a set of the most appropriate parameters and obtained the uniaxial compression stress-strain curve consistent with the test. However, when I use the same parameters for triaxial compression simulation, I find that the parameters are not applicable. The problems are as follows: The triaxial compression simulation step is to apply 10MPa confining pressure to achieve equilibrium, and then apply a certain axial strain rate.The termination condition I set is that the axial strain reaches 0.03(I think is enough..). However,I found that the stress is only about 20MPa and the stress-strain curve keeps a linear rise... How should I adjust the parameters?I think the ideal result should be that the stress reaches more than 100MPa and the stress-strain curve decreases significantly when the strain reaches about 0.015. Thanks for help! My parameters: O.materials.append(JCFpmMat(type=1,density=2640,young=20e9,poisson=0.1,tensileStrength=25e6,cohesion=50e6,frictionAngle=radians(60),label='sphere')) -- You received this question notification because your team yade-users is an answer contact for Yade. _______________________________________________ Mailing list: https://launchpad.net/~yade-users Post to : [email protected] Unsubscribe : https://launchpad.net/~yade-users More help : https://help.launchpad.net/ListHelp
