On Sat, 2006-03-18 at 11:47 -0600, Brian Turner wrote: > It installs fine but networking does not work. > > the Gmac card is recognized by the installer but in the network > control panel it is listed as disabled. When I click enable is says > it can't be found. > I tried adding a Linksys card I had lying around and it was > recognized by kudzu but does not show up in the network control > panel. Both of them are listed as being at eth0 in the hardware browser. > Netstat lists the loopback address and nothing else. I think that > means that the IP stack is fine. > Because I have similar problems with two different cards I think my > drivers are OK. > What could be between the stack and the drivers. > I am thinking a config file. > This is one of the early blue and whites that won't do two internal > HDs on the default bus. It is completely stock except the CD drive. > Maybe it needs a firmware update. > > I am using DHCP but can switch to fixed IP's if needed. > > YDL4.0.1 Blue&White G3 400 Mhz AGP Yosemite (I think)
root]# echo "alias eth0 gmac" >> /etc/modprobe.conf _______________________________________________ yellowdog-newbie mailing list [email protected] http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-newbie
