A quick shout out to see if anybody has any experience with setting up
SPI on a BeagleBoard xM Rev C. I have applied patches as stated in the
eLinux wiki to no avail. Patches are listed below:
I am running kernel 2.6.37 and u-boot 2011.06 and have applied the
following patches:
u-boot for pin muxing:
http://pastebin.archlinux.fr/434099
<http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434099&usg=AFQjCNFRHAJ90b8iCdCTPiFhHQZDBdSK2g>
kernel for spidev config and loading of the driver:
http://pastebin.archlinux.fr/434100
<http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434100&usg=AFQjCNEd7TramfvbJWPN0AfrrgCg07lkIQ>
http://pastebin.archlinux.fr/434101
<http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434101&usg=AFQjCNHX768E4py5Y1_k1U0BwiSNQBQIBg>
SPI shows up in /sys but there is no node created in /dev.
If anyone can see any faults or have any suggestions I would love to
hear them as i'm coming close to bald!
I also have a post listed on the BeagleBoard Google Board:
http://groups.google.com/group/beagleboard/browse_thread/thread/273a51d0ff91537d
Kind Regards,
Jack.
_______________________________________________
yocto mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/yocto
