On 02/28/2012 05:28 PM, Robert P. J. Day wrote:
On Tue, 28 Feb 2012, Koen Kooi wrote:
Op 28 feb. 2012, om 22:55 heeft Robert P. J. Day het volgende geschreven:
On Tue, 28 Feb 2012, Bruce Ashfield wrote:
It is true that the beagleboard is a hardware reference board in the
yocto consolidated kernel tree and meta-yocto layers. That means
that it gets the yocto standard QA builds and boot testing.
That being said, if you are looking for the latest + specific
features then you've been pointed in a good direction .. meta-ti
will meet your needs.
As for disentangling and reducing questions in this area .. rest
assured, we are working on it.
ok, that's perfectly reasonable -- meta-yocto provides a generic,
well-tested product, while the meta-ti layer provides more
leading-edge content, correct?
No, the amount of testing is not the difference, the amount of
support for the board is. Meta-ti supports the camera interfaces, 3d
engine, dsp, crypto engines, expansion boards, etc. Meta-yocto lacks
all that for beagleboard.
i understand that reasonably well, and i'll make one more
observation, then i'll shut up.
i cloned the meta-ti layer into my yocto clone, and here's the
majority of the meta-ti README:
===== start
This layer depends on:
URI: git://git.openembedded.org/openembedded-core
branch: master
revision: HEAD
URI: git://git.openembedded.org/meta-openembedded
branch: master
revision: HEAD
URI: git://git.angstrom-distribution.org/meta-angstrom
branch: master
revision: HEAD
Currently meta-ti only works with the Angstrom distribution and hence
requires the meta-angstrom layer. There are known issues when using
gcc-4.6 based toolchain from OpenEmbedded-Core, thus gcc-4.5
toolchain, provided by meta-openembedded, is needed. It is planned to
fix these shortcomings in the near future and allow building the base
BSP part of meta-ti with different distributions and layer stacks,
such as: distro-less (only with OE-Core), with Yocto/Poky, with
Angstrom or Arago.
Due to the above, it is now recommended to follow the instructions at
http://www.angstrom-distribution.org/building-angstrom
This will set it up for the OpenEmbedded-core layout instead of the
old "Classic" OpenEmbedded-dev layout. You can optionally tweak
sources/layers.txt and conf/bblayers.conf to (de)select BSP layers.
===== end
by the time i'm done reading that, i'm not sure whether i've been
told i can use yocto as long as i do the necessary prep first, or that
i should give up on yocto and just use angstrom directly. i'm fine
with either approach, but the README seems to just waffle *totally* on
which strategy to use.
quite simply, that README seems to provide nothing but more
confusion than anything else.
Congratulations you are the first beta tester for the new README.txt
language :) (patched two days ago).
Denys: I suggest
change:
"Due to the above, it is now recommended to follow the instructions at
http://www.angstrom-distribution.org/building-angstrom";
to:
"When the other layer combinations are supported instructions will be supplied
here.
Until that time please see the Angstrom setup instructions below.
*** Angstrom w/ meta-ti Layer Stack setup: ***
Please follow the instructions at
http://www.angstrom-distribution.org/building-angstrom";
etc.
_______________________________________________
yocto mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/yocto
