When I have the file named 'configure.ac', I get an error during the automake -a step. It says "configure.ac:5: error: required file 'config.h.in' not found" Did yours run no problem just by making the name change to the file?
Scott >-----Original Message----- >From: [email protected] [mailto:yocto- >[email protected]] On Behalf Of Rifenbark, Scott M >Sent: Thursday, February 21, 2013 6:03 AM >To: Khem Raj; Edward Vidal >Cc: [email protected] >Subject: Re: [yocto] adt-manual.pdf > >Thanks for getting back on this. I will check it out. > >Scott > >>-----Original Message----- >>From: [email protected] [mailto:yocto- >>[email protected]] On Behalf Of Khem Raj >>Sent: Tuesday, February 19, 2013 11:05 PM >>To: Edward Vidal >>Cc: [email protected] >>Subject: Re: [yocto] adt-manual.pdf >> >>On (09/01/13 16:59), Edward Vidal wrote: >>> Hello, >>> I was testing the example 4.1 Autotools-Based Projects >>> should the file "configure".in be "configure.ac" >>> this is the error that I get when I execute aclocal >>> aclocal >>> aclocal: warning: autoconf input should be named 'configure.ac', not >' >>> configure.in' >>> Any help will be appreciated. >> >>yes configure.ac is right naming. Have you filed a bug for it in >>bugzilla ? if not I would suggest to file one >>_______________________________________________ >>yocto mailing list >>[email protected] >>https://lists.yoctoproject.org/listinfo/yocto >_______________________________________________ >yocto mailing list >[email protected] >https://lists.yoctoproject.org/listinfo/yocto _______________________________________________ yocto mailing list [email protected] https://lists.yoctoproject.org/listinfo/yocto
