As for putting the image on a cf card, it may depend on which file system you would use.
I am using ext3 on a cf card, following the instructions for installing to a hard drive on this page: https://wiki.yoctoproject.org/wiki/How_do_I Luck to you. "Florin Cristian Dan" <dan.florincrist...@gmail.com> wrote in message news:cabzodptr4xswpztyxwnxoq3xpezvmhulu5vx9qgxotkbht-...@mail.gmail.com... > Hello, i've managed to burn the BSP image (emenlow) on a usb stick, on > booted on my target machin, apparently it works fine, but i would like to > know how can i eliminate that 10 day timeout, i've tried to enter the > address that is given in the splash http://yoctoproject.org/tlk but is not > working ("page not found"), this is one question, and another question is: > currently i'm booting the image from a USB stick, but i want to make it > defintive and run it from the targets CF memory, the principple of writing > the image to the CF memory is the same as writing the image for the USB > stick? > Thank you very much > Best regards > -------------------------------------------------------------------------------- > _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto