Hi,
I need to create a local BSP layer using Yocto-bsp create command
without the use of Git.
yocto-bsp create mylayers qemu -s
Which qemu architecture would you like to use? [default: i386]
1) i386 (32-bit)
2) x86_64 (64-bit)
3) ARM (32-bit)
4) PowerPC (32-bit)
5) MIPS (32-bit)
3
Would you like to use the default (3.8) kernel? (y/n) [default: y] y
Do you need a new machine branch for this BSP (the alternative is to re-use an
existing branch)? [y/n] [default: y] n
Getting branches from remote repo
git://git.yoctoproject.org/linux-yocto-3.8.git...
Thanks with Regards
---------------------------------------------------------------------------------------------
Dilip Kumar B | PES
L&T Infotech, Plot No. 25-31, EPIP 2nd Phase, KIADB Indl Area, Whitefield,
Bangalore - 66
Off: 91-80-66242053
[email protected]
--------------------------------------------------------------------------------------------
________________________________
The contents of this e-mail and any attachment(s) may contain confidential or
privileged information for the intended recipient(s). Unintended recipients are
prohibited from taking action on the basis of information in this e-mail and
using or disseminating the information, and must notify the sender and delete
it from their system. L&T Infotech will not accept responsibility or liability
for the accuracy or completeness of, or the presence of any virus or disabling
code in this e-mail"
_______________________________________________
yocto mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/yocto
