I build on i.mx (NXP) machine, I want to get configured as dhcp (no
static)...
------ Original Message ------
From: "Trevor Woerner" <[email protected]>
To: "Peter Balazovic" <[email protected]>
Cc: "Yocto list discussion" <[email protected]>
Sent: 5/12/2017 9:32:17 PM
Subject: Re: [yocto] dhcp eth0 network
Hi Peter,
For what MACHINE are you building? What's your target hardware? Can
you summarize the steps you took to build your image?
What do you want eth0 to do? dhcp or static ip?
Best regards,
Trevor
On Fri, May 12, 2017 at 12:01 PM, Peter Balazovic
<[email protected]> wrote:
Dears,
I got Yocto image and unfortunatelly network is not somehow enabled &
proprely configured. After "ifconfig" no eth0 configured.
ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
....
/etc/network
ls
if-down.d if-post-down.d if-pre-up.d if-up.d
How should I setup "eth0" to get network working properly?
Thanks.
--
_______________________________________________
yocto mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/yocto
--
_______________________________________________
yocto mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/yocto
