KERNEL=="eth*", SYSFS{address}=="AA:BB:CC:DD:EE:FF", NAME="eth1"
should work. Try to use lower case only. Maybe eth1 is used by something else ? What about using wlan0 or something ? A better / cleaner way to rename interfaces is /etc/iftab ( man iftab ) : An example is wlan0 mac AA:BB:CC:DD:EE:FF For more infos search the gentoo forum ( http://forums.gentoo.org ) for iftab and you will plenty of posts about it. Best regards, Norman Am Donnerstag, den 21.09.2006, 18:33 +0200 schrieb Elimar Riesebieter: > Hi all, > > I am running > > zd1211rw 4-1:1.0: firmware version 4605 > zd1211rw 4-1:1.0: zd1211 chip 6891:a727 v4330 high 00-14-7c RF2959_RF pa0 g--- > > > IEEE 802.11b/g ESSID:"BLO" Nickname:"zd1211" > Mode:Managed Frequency:2.462 GHz Access Point: XX:XX:BB:LL:KK:00 > Bit Rate:54 Mb/s > Link Quality=98/100 Signal level=91/100 > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:0 Missed beacon:0 > > in wpa/tkip mode. > > I have a wired interface eth0 and the wireless one which was > detected as eth1 but named as eth3. How do I fix the name of the > wireless stick to eth1? I've played with udev: > KERNEL=="eth*", SYSFS{address}=="AA:BB:CC:DD:EE:FF", NAME="eth1" > or > KERNEL=="eth*", SYSFS{idVendor}=="6891", SYSFS{idProduct}=="a727", NAME="eth1" > > but doesn't helped. > > Could one advice me, please? > > > Elimar ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys -- and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Zd1211-devs mailing list - http://zd1211.ath.cx/ Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs