General discussion of using zenoss system <[email protected]> writes: >> I've got something for the group to ponder over the weekend, if you >> wish to that is... I'm trying to track the number of BGP peers on >> our edge routers, and I can get the number and store it as a GAUGE to >> give the appropriate graph as into quantity of peers. However, I'd >> like to also track the rate of change of this number, so I created >> another data point for each data source to be DERIVE. [...] > >This is a known limitation/problem/decision. Up until reading this >post I had never seen a good reason to record the collected value of a > >single OID into multiple data points, but this makes complete sense. >I've added ticket #2506 to allow the same value to be recorded in the >RRD file of multiple data sources.
I have a problem that's sort of 90 degrees off from this, but similar conceptually... We run Trango Broadband radios here; all the APs (hub) and SUs (spoke) are monitorable via SNMP, with one big caveat... the AP counters are all accessible normally, but all the SU counters cannot be polled directly, they must be collected from the AP under an enterprises subtree. So... I need to monitor devices A, B, and C (in terms of reachability, etc., as well as perf graphs) but the data for devices A, B & C has to come from device X. Is this possible with Zenoss today? How would I go about doing this? -Adam Thompson Divisional IT Department, St. James-Assiniboia School Division 150 Moray St., Winnipeg, MB, R3J 3A2 [EMAIL PROTECTED] / tel: (204) 837-5886 x222 / fax: (204) 885-3178
_______________________________________________ zenoss-users mailing list [email protected] http://lists.zenoss.org/mailman/listinfo/zenoss-users
