On Apr 11, 2008, at 3:37 PM, magnachef wrote:
I have bonded ethernet ports (eth0 and eth1) which are both 1 Gig
ports. The bonded interface is bond0, and shows up as 10 Mbps in
SNMP. The problem is that I this interface is exceeding the
threshold set for the ethernetCsmacd type interfaces. I created a
template "bond0" so that I can remove the threshold, but I can't
figure out how to change the interface Type.
Does anyone know how to do this, so that when I model, it will
assign all bond0 interfaces to type bond0 instead of ethernetCsmacd?
This is a common problem with bond interfaces on Linux. Check out the
article below for a way to correct the ifSpeed reported by these
interfaces.
http://whocares.de/2007/12/28/speed-up-your-bonds/
_______________________________________________
zenoss-users mailing list
[email protected]
http://lists.zenoss.org/mailman/listinfo/zenoss-users
