Hi all, This is my first post on this forum so please be charitable :-). From a few days I'm using Zenoss Core 2.2.3 and I have a problem with monitor Cisco 3560 Switch via SNMP. I'm adding a new device and in port list I have only VLAN interfaces, there is no physical interfaces. Switch is with 8 GigabitEthernet ports. When I try to add Cisco 2950 Cat. with fastethernet, ports are added for monitoring, but only first 8 from 24. When I'm trying test "Data source" all interfaces are counted
Code: Executing command against tr-zt-r07-sw1 IF-MIB::ifInErrors.1 = Counter32: 0 IF-MIB::ifInErrors.2 = Counter32: 0 IF-MIB::ifInErrors.10001 = Counter32: 0 IF-MIB::ifInErrors.10002 = Counter32: 0 IF-MIB::ifInErrors.10003 = Counter32: 0 IF-MIB::ifInErrors.10004 = Counter32: 0 IF-MIB::ifInErrors.10005 = Counter32: 0 IF-MIB::ifInErrors.10006 = Counter32: 0 IF-MIB::ifInErrors.10007 = Counter32: 0 IF-MIB::ifInErrors.10008 = Counter32: 0 IF-MIB::ifInErrors.10101 = Counter32: 0 IF-MIB::ifInErrors.10501 = Counter32: 0 DONE in 0 seconds Anyone have an idea where is a problem? I will be thankfull for any help. Regards Jerzy -------------------- m2f -------------------- Read this topic online here: http://community.zenoss.com/forums/viewtopic.php?p=22978#22978 -------------------- m2f -------------------- _______________________________________________ zenoss-users mailing list [email protected] http://lists.zenoss.org/mailman/listinfo/zenoss-users
