Dear all,
I was trying to look into the wire protocol used by zeromq, here are some
things I would like to ask:
1. I use wuserver/wuclient when I connect REQ to REP, the REQ send 2 bytes:
[01 00]
when the connection accepted by REP, the REP send 2 bytes reply: [01 00]
Is this the handshaking mechanism or just the mechanism to tell each
side about the connection?
2. I haven't tried other combinations (PUSH/PULL, PUB/SUB, etc) are there
more information about the wire level protocol? From the manual, zmq_tcp(7),
there just describing the payload formating.
Regards,
Herry Sitepu
_______________________________________________
zeromq-dev mailing list
[email protected]
http://lists.zeromq.org/mailman/listinfo/zeromq-dev
