Then you are not running zim.py and setup.py with the same python installation.
Regards, Jaap On Fri, Apr 26, 2013 at 5:53 PM, Alexander Bryan <[email protected]> wrote: > I ran "sudo port install py26-gobject" (note: not included with the other 4 > modules in the install instructions for Mac), and the module installed > successfully, yet the same error came up. Not a huge deal since I can > successfully run zim from the source, but if you happen to have other ideas > at the top of your head, please share. (Doesn't seem worth too much > troubleshooting if I can run it fine from the source). Thanks so much for > your help Jaap! > > Best, Alex > > > On Fri, Apr 26, 2013 at 11:42 AM, Jaap Karssenberg > <[email protected]> wrote: >> >> On Fri, Apr 26, 2013 at 5:39 PM, Alexander Bryan <[email protected]> wrote: >> > Ah... Thanks for clarifying. I get an error when running "./setup.py >> > install": >> > >> > Traceback (most recent call last): >> > File "./setup.py, line 22, in <module> >> > from zim import __version__, __url__ >> > File "/Users/ambrya/source/zim-0.59/zim/__init__.py", line 115, in >> > <module> >> > import gobject >> >> >> That means you have not all prerequisites in place. In this case it is >> the python gobject module that apparently is not found. >> >> Likely you get the same error when you run "./zim.py". >> >> Regards, >> >> Jaap > > _______________________________________________ Mailing list: https://launchpad.net/~zim-wiki Post to : [email protected] Unsubscribe : https://launchpad.net/~zim-wiki More help : https://help.launchpad.net/ListHelp
