I built the driver with GLDv3 :

# dladm show-link
vfe0            type: non-vlan  mtu: 1500       device: vfe0

What was your idea with a VLAN ?


On Jun 5, 2008, at 1:34 PM, James Carlson wrote:

Alain Durand writes:
and here are the routes seen from the zone :

That doesn't look quite right; the route should be visible there
because the next hop address is reachable.

If needed I could use IP instances (I'm running Solaris 10 Update 5),
but have only one physical ethernet interface, is that possible ?

Yes, if you can configure a VLAN on this interface using dladm.  (I'm
guessing that 'vfe' isn't a GLDv3 driver, and thus you can't do that.)

-- James Carlson, Solaris Networking <[EMAIL PROTECTED] > Sun Microsystems / 35 Network Drive 71.232W Vox +1 781 442 2084 MS UBUR02-212 / Burlington MA 01803-2757 42.496N Fax +1 781 442 1677
zones-discuss mailing list

zones-discuss mailing list

Reply via email to